GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 2.GQ Geiger Muller Counter
 GMC-500+ vs GMC-600
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ceandre27

9 Posts

Posted - 02/07/2018 :  06:46:22  Show Profile  Reply with Quote
Hi ppl!

I just got my GMC-600, and I'm running some tests on them both sametime.
Then, I just noticed something weird on CPM / uSv/h.

On GMC-500+ (M4011 + SI-3BG tubes) I got:
uSv/h: 0.15
1427 CPM after 1 hour

On GMC-600 (SBT-11 pancake) I got:
uSv/h: 0.09
1755 CPM after 1 hour

I know, SBT-11 is more sensitive, but WHY I got lower uSv/h even with MORE CPM ??


Image Insert:

70980 bytes

Edited by - ceandre27 on 02/07/2018 06:48:22
Reply #1

marzio

Italy
16 Posts

Posted - 02/07/2018 :  11:30:37  Show Profile  Reply with Quote
i hope that this image can help you.
GMC-600+ (LND7317)
your GMC-600 is wrapped in nylon
may it lose sensitivity compared to the GMC-500?


Image Insert:

79279 bytes

Marcus
Go to Top of Page
Reply #2

ceandre27

9 Posts

Posted - 02/07/2018 :  14:13:47  Show Profile  Reply with Quote
Hi Marzio!

I open a hole on plastic film at sensor window :)

What I think weird it's ratio CPM x uSv/h, from one unit to another. 600 unit got MORE CPM than, but it's counting LESS on uSv/h unit.

Both turned on same time, side by side. I know which 600 must get more CPM because it's more sensitive, but what intrigues me is the lower uSv / h value

Carlos
Go to Top of Page
Reply #3

marzio

Italy
16 Posts

Posted - 02/07/2018 :  14:41:22  Show Profile  Reply with Quote
hi Carlos,
have you modify the 'calibrate' menu?
the relation among CPM and uS/h can be changed in base of the sensibility of the tube.
if you have changed the relation then try to execute a 'factory reset'.
ciao, marzio

Marcus
Go to Top of Page
Reply #4

ceandre27

9 Posts

Posted - 02/07/2018 :  18:53:21  Show Profile  Reply with Quote
Hi Marcus,

No, I not changed anything on calibrate menu :|

Go to Top of Page
Reply #5

ZLM

1261 Posts

Posted - 02/07/2018 :  22:03:54  Show Profile  Reply with Quote
ceandre27, each tube has slight different conversion rate. In your case, you can adjust the conversion rate. Go to Init menu and then select Calibration 1, change 300 to 230.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.08 sec. Snitz's Forums 2000