GQ Electronics Technical Support Forum


GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 4. GQ Hot Air Soldering Rework Station
 Steps to fix your soldering iron
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

salvadortorres

2 Posts

Posted - 01/20/2018 :  03:07:20  Show Profile  Reply with Quote
Steps to fix your soldering iron. There are 5 most important steps you must follow,
1) Factors of a Broken Soldering Iron
If your filament is broken.Then the soldering iron is not working, first is the wires on the plug to your soldering iron, you have to test it using a multitester
2) The Materials
You can use it as some electrical tape or tape
3)Removing the Filament
You can go with any types of steps to remove the filament of the soldering iron depending on the type of your soldering iron.
4)Removing the Filament 2
You can remove it by the use of cutter pliers.
5) Your Soldering Iron Is Now Working.
At last test your soldering iron.
Great tutorial on this will get through online.Search on web and you can see lots of services/ sites are helps (https://www.essayguardian.com) you on any topic you need.





Edited by - salvadortorres on 01/20/2018 03:08:40
Reply #1

CoraDias

USA
1 Posts

Posted - 02/23/2018 :  09:40:10  Show Profile  Reply with Quote
Hi...Any tips to getting the solder to adhere to the board better? I'm trying to replace a transistor on my early stern SDB and the solder is collecting on the leg of the transistor, but I cannot get it to sit in the hole that the leg sits in to make good contact.

https://www.7pcb.com/

Edited by - CoraDias on 03/16/2018 13:14:59
Go to Top of Page
Reply #2

radciffkaty1

12 Posts

Posted - 03/30/2018 :  05:14:22  Show Profile  Reply with Quote
Nice tips, @salvadortorres !!!
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000