GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 2.GQ Geiger Muller Counter
 GMC-300E Questions		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

FluteDog

USA
1 Posts
Posted - 12/21/2013 :  18:27:32  Show Profile  Reply with Quote
Hello. I have a few questions.

1. Where exactly is the location of the tube? I want to make sure my device is facing the object that I am measuring.

2. How long should I keep the device on the object I want to measure? Since it is in uSv/h then do I have to measure for one hour?

3. How would I go about calibrating this device?

I'm using this device for a science fair project. Thank you in advance.
Edited by - FluteDog on 12/22/2013 15:37:08
Reply #1

ZLM

1261 Posts
Posted - 12/23/2013 :  14:44:54  Show Profile  Reply with Quote
1.The tube is located at the lower edge of the unit. It closes to the 4 keys.
2.For an accurate CPM reading, at least one minute needed.
3.By default, the device is calibrated to regular range measurement. You do not need to recalibrate agin unless the tube been changed.

You need a standard source to recalibrate it.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.05 sec. Snitz's Forums 2000