GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 4. GQ Hot Air Soldering Rework Station
 5200 Iron Temp Stuck at 480C...
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

skullen

3 Posts

Posted - 05/10/2017 :  04:44:12  Show Profile  Reply with Quote
My 5200's recently developed a problem. Regardless of where I turn the iron heater knob, the display shows the iron temp warm up to 480C every time. The iron is hot and works, but I need the ability to adjust the temp. Any ideas? A schematic of the iron section would help. Thank you.
Reply #1

skullen

3 Posts

Posted - 05/13/2017 :  14:06:06  Show Profile  Reply with Quote
Turned out to be a bad pot. Wiper was somehow shorted to one of the other pins. Swapped it with the other 5k pot for the air temp and it works fine. 480C is evidently the max temp and should've been a clue. I'll post a link to a replacement part once I've found it and have verified that it fits. Hope this helps someone.
Go to Top of Page
Reply #2

skullen

3 Posts

Posted - 05/25/2017 :  04:41:27  Show Profile  Reply with Quote
Took apart the pot and cleaned inside. Then it tested fine. It's now reinstalled and working as expected.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.05 sec. Snitz's Forums 2000