GQ Electronics Technical Support Forum
.


GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 3. GQ EMF EF Meter RF Spectrum Power Analyzer
 Measuring ELF
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Independent_Worm_Saloon

USA
3 Posts

Posted - 08/08/2020 :  17:25:31  Show Profile  Reply with Quote

I'm trying to measure ELF with my EMF-390 but I can't seem to find a function to do this. I've seen quite a few videos mention ELF but without showing how to do it. Is it possible? And if so, can someone clue me in? Thanks.

Reply #1

EmfDev

1438 Posts

Posted - 08/10/2020 :  09:32:41  Show Profile  Reply with Quote
Hello, yes it can detect ELF. Just point the device close to the source and read it with the EMF/mG from the unit.
Go to Top of Page
Reply #2

Bill D.

USA
44 Posts

Posted - 08/10/2020 :  15:20:44  Show Profile  Reply with Quote
In table mode you can read the frequency of the EMF.
Go to Top of Page
Reply #3

rfrazier

USA
44 Posts

Posted - 08/14/2020 :  19:51:14  Show Profile  Reply with Quote
Be sure to look at the owners manual on the company website to get familiar with the menu controls. If holding the device horizontal with the buttons to the right, the buttons are, from the top, POWER, UP, DOWN, BACK. To change screen modes, press the BACK button to get a menu. Use the arrow buttons to select a screen. Either wait for it to set or press the POWER button briefly to set. I'm assuming you're talking about magnetic fields, which this instrument refers to as EMF.
* On the all in one screen, press UP repeatedly until the main display shows EMF.
* On the vertical mode screen, and now holding vertically, press the UP button (now pointing right) until it selects EMF/EF. Press the DOWN button (now pointing left) to switch between EMF and EF.
* On the table mode screen, now holding horizontally, press the UP button until it selects EMF/EF. You can read total EMF and EMF in each axis.
* On the emf graphs screen, press the UP button until it selects EMF/EF to read total EMF or press the UP button until it selects XYZ-EMF to read the EMF in each axis.
Ron

-----
Ron Frazier - In training with the Building Biology Institute (https://buildingbiologyinstitute.org/) to become an independent Electromagnetic Radiation Specialist (EMRS). We measure, document, analyze, and recommend mitigations for harmful EMF exposures.
All my statements are mine alone though.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.14 sec. Snitz's Forums 2000