|
frank.mathieu@GQ
Germany
36 Posts |
 Posted - 04/27/2026 : 04:02:07
|
I use the tool quite extensively to find sources that radiate my home. In RF vertical mode, the tool displays the frequency that issued the max power density during the last second. THANK YOU!!!
I live in Germany, so Frequency ranges are used differently as they are in the US.
Using the displayed frequencies (420-450MHz) I found that the most likely source for RF that hits me every couple of seconds even during weekend nights with power densities between 10+ up to 200µW/m² comes from TETRA radios used by the military security personnel (working on the air base that is 600m from my home) doing their security patrol.
My meter recorded 'Mixed' even when the peak is much higher than the average 0.8µW/m².
can I make the device populate the frequency in the saved data?
Thank you :) |
|
can gq emf-390 save measured peak frequencies ?
