| T O P I C R E V I E W |
| flash |
Posted - 12/06/2019 : 12:25:12
I purchased an EMF-390 in hopes of being able to locate the source of interference for the open/close signal for my electrically operated driveway gate, such that I have to be very close to the antenna with the various signal devices to operate the gate when a system of landscaping lights near the gate is on. The EMF-390 appears to be well beyond my technical knowledge, so any help would be greatly appreciated. |
| 7 L A T E S T R E P L I E S (Newest First) |
| wolffmichael |
Posted - 03/11/2020 : 08:34:47
Thanks! |
| EmfDev |
Posted - 03/11/2020 : 08:09:58
Hi wolffmichael, in spectrum band, hold the down button to display the selection screen for the other bands. then press down again once it popped up. then press select/menu key. |
| wolffmichael |
Posted - 03/11/2020 : 07:31:48
How can I switch the spectrum analyzer band to 240MHz-1040MHz? |
| flash |
Posted - 12/06/2019 : 14:38:07
thank you |
| EmfDev |
Posted - 12/06/2019 : 14:13:37
Switch to the spectrum analyzer band to 240MHz-1040MHz. You can see there the remote signal around 310-315 if that's correct. You can zoom in to those values to check. |
| flash |
Posted - 12/06/2019 : 14:04:13
The gate people say it is in the 310 to 315 MHz range.
|
| EmfDev |
Posted - 12/06/2019 : 13:37:49
Hi flash, you need to check in which frequency does your remote operate? You can check the spectrum mode is there's something being detected when using the remote. |
